Mechanical License For Pasco County (GITS©)

Mechanical contractor means a contractor whose services are unlimited in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design, if not prohibited by law, central air-conditioning, refrigeration, heating, and ventilating systems, including duct work in connection with a complete system if such duct work is performed by the contractor as necessary to complete an air-distribution system, boiler and unfired pressure vessel systems, lift station equipment and piping, and all appurtenances, apparatus, or equipment used in connection therewith, and any duct cleaning and equipment sanitizing that requires at least a partial disassembling of the system; to install, maintain, repair, fabricate, alter, extend, or design, if not prohibited by law, piping, insulation of pipes, vessels and ducts, pressure and process piping, pneumatic control piping, gasoline tanks and pump installations and piping for same, standpipes, air piping, vacuum line piping, oxygen lines, nitrous oxide piping, ink and chemical lines, fuel transmission lines, liquefied petroleum gas lines within buildings, and natural gas fuel lines within buildings; to replace, disconnect, or reconnect power wiring on the load side of the dedicated existing electrical disconnect switch; to install, disconnect, and reconnect low voltage heating, ventilating, and air-conditioning control wiring; and to install a condensate drain from an air-conditioning unit to an existing safe waste or other approved disposal other than a direct connection to a sanitary system. The scope of work for such contractor also includes any excavation work incidental thereto, but does not include any work such as potable water lines or connections thereto, sanitary sewer lines, swimming pool piping and filters, or electrical power wiring (s. 489.105).

Mechanical License Courses

Exams For Mechanical License

Mechanical Exam

  • Exam: MAE1Pa
  • Testing Method: Open book
  • Testing Company: GITS (Gainesville Independent Testing Service)
  • Hours Alloted: 4h
  • Types of Questions: Multiple Choice
  • Number of questions: 100
  • Subjects Involved:
    • Code Compliance
    • Fuel Gas
    • Ductwork - Systems and Sizing
    • Load Calculations
    • Boilers
    • General
    • Maintenance and Service
    • Controls
    • Piping
    • Insulation
    • Psychrometrics

Business and Law Exam

  • Exam: AAE2A
  • Testing Method: Open Book
  • Testing Company: GITS (Gainesville Independent Testing Service)
  • Hours Allotted: 2h
  • Types of Questions: Multiple Choice
  • Number of questions: 50
  • Subjects Involved:
    • Insurance Laws
    • Tax Laws
    • Safety
    • Management
    • Lien Laws
    • Employment Laws
    • General Accounting

List of Books For Mechanical License

The books set includes all required references for both the Mechanical and Business Procedures exams. Orders placed before 2 PM are shipped the same day via UPS and a tracking number is emailed before 3 PM.

PASCO COUNTY (FLORIDA) MECHANICAL (GITS) COURSE - BOOK SET WITHOUT TABS INCLUDES ALL BOOKS FOR TRADE AND BUSINESS EXAMS

Sales price: $1,300.15

PASCO COUNTY (FLORIDA) MECHANICAL (GITS) COURSE - BOOK SET WITH TABS INCLUDES ALL BOOKS FOR TRADE AND BUSINESS EXAMS

Sales price: $1,400.15

Mechanical Books

OSHA is required for both the business and the trade exams.

Business and Law Books

OSHA is required for both the business and the trade exams.